Sensors and Systems for combustion technology

Control Drive 6 Nm, Type 662R2127

Control drive 6 Nm
  • Running time 60 seconds to 90°
  • Control voltage 230 VAC / 50 Hz, three-point-step
  • 2 Limit switches for limitation of operating displacements to 90° (factory-installed)
  • Without additional switches
  • 1 Potentiometer NOVOTEC, 5 kΩ, as position feedback
  • Electrical manual operation OPEN/CLOSE via push-button
  • Protection type IP54


Note: Other types on request.


       

      Typ 662R2127 in variant “Standard”

      Output shaft

      Ø10 x 25 mm, parallel key 3 x 3 x 8 mm

      Voltage

      230 VAC / 50 Hz

      Running time

      60 s

      Angle of rotation default

      90°

      Controlling

      TPS

      Protection type

      IP54

      Electrical manual operation

      OPEN / CLOSE-controlling via internal push-buttons

      Permitted ambient temperature

      -20…+60°C

      In line with its "one-stop-shop" motto, LAMTEC also offers motors for driving the flaps and valves on your combustion plants. The motors, designed for interconnection with electronic systems, have been tested in industrial applications and carry safety approval.

      It goes without saying that these motors comply with the safety requirements for the use and positive connection of tested potentiometers, as well as the principal criterion for precise electronic interconnection: zero-float feedback connection.

      There are four types of standard motor available straight from LAMTEC stores: the 6 Nm, 20 Nm, 30Nm and 60 Nm, all with a 60 sec. operating time.

      Apart from these three standard models, we can also supply motors of up to 200 Nm equipped with different limit switches and potentiometers, and with different operating times.

      Furthermore we offer linear and non linear Gas control valve with a nominal diameter between DN25 and DN200. These valves are installed with positive locking at the motors. 

      These motors are only released for activation of the actuators of combustion applications in combination with LAMTEC Combustion- and Compound Management-Systems type ETAMATIC, FMS or VMS.

      Please contact our sales department by writing an e-mail, contact form or call +49 6227 6052-0.

      We will help you to select the optimum control drive for your application.